Kyocera TJEP RE-BAR XP 25 Bedienungsanleitung Seite 38

5.1.9. Battery-saving function
The machine will automatically shut down
after 10 min stand-by without being used.
5.2. WARNING:
ƒ When the main switch is set to
!
1, do not place your fingers near
the curl guide or other moving
parts of the machine! Avoid switching the
main switch repeatedly between 1 and 0.
This can cause a machine breakdown. Do
not touch the wire while the machine is
x
running.
5.3. Insert the battery in the machine,
and set the main switch to 1.
Battery
5.4. Release the trigger lock, before
starting to tie.
Trigger lock
5.5. How to replace the wire
coil.
WARNING:
5.5.1. Set the main switch to 0
!
position, activate the trigger
lock and remove the battery.
Battery
38 · www.tjep.eu
5.5.2. Push the release lever until it is
caught by the release stopper.
Release lever
Release stopper
5.5.3. Remove the wire coil.
Wire guide
Wire
5.5.4. Push the reel stopper to release
the reel stay and open it at the same
time, and remove the wire coil.
Reel stay
5.5.5. Load new wire coil and repeat
from step 5.1.4.
6.1. The torque dial adjusts the tension
of the ties.
We recommend:
ƒ 2 wraps = position 1 - 6
ƒ 3 wraps = position 6 - 10
6.2. Perform a test tie, to check if the
torque dial is set correctly.

Reel stopper
x