Herunterladen Diese Seite drucken

Kyocera TJEP RE-BAR XP 25 Bedienungsanleitung Seite 35

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

4. Safety instructions
Caution
To avoid serious injuries to
!
persons or property, please read
these safety instructions carefully
and make sure you understand them.
4.1. Points of attention when
using the RE-BAR tier.
Using the RE-BAR tier for other purposes
or other applications than described in this
manual can result in serious accidents.
Please make sure that you follow all in-
structions in the manual. People who have
nothing to do on the work site, especially
children, should be kept out of the work
site and should not have access to this
equipment.
4.1.1. Use appropriate protection gear.
Employer and operator must make
sure that the operator uses proper eye
protection when the tool is used. This
protection must comply with current
laws and norms.
4.1.2. Ear protection can be necessary.
On a lot of work sites, it can be necessary
to wear ear protection, to avoid perma-
nent damage to the ears. Employers and
employees must make sure that proper ear
protection can be found and is used on the
work site.
4.1.3. No children near the RE-BAR tier.
Do not allow spectators, especially
children, near the machine while working
with it.
4.1.4. Do not use the RE-BAR tier near
flammable substances.
Never use the RE-BAR tier near any flam-
mable substances or fumes. The fumes
from these can be sucked into the engine
and cause an explosion.
4.1.5. Do not use the RE-BAR tier in wet
or damp environments.
If the RE-BAR tier is used in direct rain
or water, damp environments or similar,
the risk of getting an electrical chock is
increased. Do not leave the RE-BAR tier
where it can be exposed to this.
4.1.6. Check the parts of the RE-BAR tier
before inserting the battery.
Check that all screws are tightened prop-
erly. Improper tightening of screws can
result in an accident or breakage. If parts
are missing or need to be repaired, contact
your dealer immediately. Use only parts
approved by the manufacturer.
4.1.7. Set the main switch to 0 position
and lock the trigger when changing or
adjusting the wire coil or if a fault oc-
curs and the machine cannot be used.
If the machine is left on, it may cause
damage.
4.1.8. Keep clear of the wire coil during
use of the RE-BAR tier.
If not, it can cause serious injury.
4.1.9. Keep clear of the curl guide during
use of the RE-BAR tier.
You may get caught in the wheels and
suffer serious injury.
4.1.10. Do not point the RE-BAR tier
towards others during use.
People can get hurt if they are caught in the
machine during use. When tying, be careful
and stay clear of the machine mouth and
curl guide.
4.1.11. Do not touch the trigger unless
you have to.
When carrying the RE-BAR tier and when
not tying, remember to set the main switch
to 0 position, and lock the trigger. If not, you
will risk activating the RE-BAR tier uninten-
tionally and cause a dangerous situation.
4.1.12. Do not use the RE-BAR tier dur-
ing a malfunction.
If the RE-BAR tier does not work correctly,
set the main switch to 0 position and lock
the trigger, before checking what is wrong.
If necessary, contact your dealer and have
the RE-BAR tier repaired.
4.1.13. When inserting the battery, check
the following points. Do not load a wire
coil in the RE-BAR tier if:
ƒ There is a sound from the curl guide,
even though the RE-BAR tier is not in
use.
ƒ The RE-BAR tier is warmer than usual,
smells odd, or a noise is coming from the
machine when not in use.
www.tjep.eu · 35

Werbung

loading

Verwandte Produkte für Kyocera TJEP RE-BAR XP 25

Diese Anleitung auch für:

Tjep re-bar xp 40Tjep re-bar xp 58