Kyocera TJEP RE-BAR XP 25 Bedienungsanleitung Seite 37

5. How to use
5.1. Loading the wire coil.
WARNING:
Set the main switch to 0 position,
!
activate the trigger lock and
remove the battery.
5.1.1. Push the release lever until it is
caught by the release stopper.
Release lever
Release stopper
5.1.2. Push the reel stopper to open the
reel stay.
Reel stopper
5.1.3. Insert the wire coil with left side
inwards, with the wire-end upwards and
forward
Close the reel stay and secure the reel
stopper.
Reel stay
5.1.4. Release the wire and remove the
rubber band
5.1.5. Insert the tip of the wire into wire
guide C, through the gap of the feeding
gears and all the way into the machine
arm. (10 - 20 mm).
Wire guide
If the window is dirty and it is difficult to
determine the position of the wire guide C,
clean the inside of window with a soft cloth.
5.1.6. Push the release stopper.
Make sure that the release lever is back in
original position and that the feeding gears
are clamping the wire.
Feeding gears
5.1.7. Make sure that the wire is tight
and firm.
Prevent the wire from curling up behind the
wire coil. This may cause a jam.
5.1.8. Adjusting the wraps
By default the machine is set for 3 wraps.
Changing the setting to 2 wraps: Turn off
the machine on the main switch. Press and
hold the trigger while turning on the main
switch. The machine is now set for 2 wraps
per tie. If the machine is turned off, it will
automatically be set for 3 wraps again.
Wire guide C
Release stopper
Release lever
www.tjep.eu · 37