Werbung
Verfügbare Sprachen
Verfügbare Sprachen
The lid is not a serviceable part. The yellow cover must not be removed and doing so will invalidate warranty.
It is advisable to have an annual check on all plumbing and fi ttings to prevent leaks and blockages.
Helpful Hint - The grey waste tanks have integrated threaded inserts which can be used to attach the Gulper grey waste pump directly to the tank.
9.
TROUBLESHOOTING
Problem
Sensor fails to operate pump
Sensor is operating pump continuously
10.
WINTERIZING
The system must be fully drained, including the contents of the grey waste tank. If water is allowed to freeze in the system, serious damage to the plumbing, pump
and/or accessories may occur. Failures of this type will invalidate the warranty.
11.
SERVICE SUPPORT DETAILS
For installation or service advice please contact Whale® Customer Support:
Whale Support
Tel: +44 (0)28 9127 0531
Email: info@whalepumps.com
www.whalepumps.com
12.
EU DECLARATION OF CONFORMITY
We hereby declare, under our sole responsibility, that the enclosed equipment complies with the provisions of the following EC Directives.
Electromagnetic Compatibility Directive 2004/108/EC on the approximation of the laws of the Member States relating to electromagnetic compatibility.
CE mark affi xed: May 2017
Basis on which conformity is declared - The above equipment complies with the protection requirements of the EMC Directive.
Standards applied
2013/53/EU
ISO10133:2012
EN55014-1:2006
EN55014-2:1997+A2:2008
EN28846 :1993
Richard Bovill
Engineering Director
13.
PATENTS AND TRADEMARKS
WHALE® and GULPER® are registered trademarks of Munster Simms Engineering Limited, Bangor, Northern Ireland trading as Whale.
14.
WARRANTY
This Whale® product is covered by a 1 year warranty. Please see the enclosed document for details of our Statement of Limited Warranty.
©Copyright Whale 2017 - All rights reserved. Reproduction in whole or in part without permission is prohibited. Whale's policy is one of continuous improvement and we
reserve the right to change specifi cations without prior notice. Illustrations are for guidance purposes only. Neither the accuracy nor completeness of the information
contained in this or any Product literature is guaranteed by the Company and may be subject to change at its sole discretion. Please note that by contacting Whale
Support you will be indicating your consent to receiving product updates, recall information, help guides and appropriate marketing messages from us via post, email or
telephone unless you indicated an objection to receiving such messages.
Possible Cause
No power to sensor
Fuse has blown
Dirt/debris has covered sensor
Pump is faulty
Sensor is faulty
Dirt/debris has covered sensor
Tank not emptying water
Incorrect wiring
Sensor is faulty
Pump is faulty
Whale Support (The Americas)
Tel: +1 616 897 9241
Email: usasales@whalepumps.com
Recreational Craft Directive
Extra-low voltage DC Installation
EMC Emissions
EMC Immunity
Ignition Protection
Potential Solution
Check power supply, leads and connections
Replace fuse
Carefully remove the lid from the tank, and clean debris
from the sensor faces - Figure 10
Replace pump
Replace tank lid (see table Specifi cation for appropriate
service kit)
Carefully remove the lid from the tank, and clean debris
from the sensor faces - Figure 10
Check water supply level and pressure relief settings are
appropriate for the system
Check wiring Figures 8A / 8B
Replace tank lid (see table Specifi cation for appropriate
service kit)
Remove pump and check non-return valve and remove any
debris. Replace non-return valve if necessary.
Werbung
