Problem, Cause, Solution; No Reaction To Control Signal - Assa Abloy Hi-O Technology OneSystem N5950 Installations- Und Montageanleitung

EN
60

Problem, cause, solution

No reaction to control signal

Problem
The lock is not unlocked, even
though the unlocking control
input is activated.
Possible cause Solution
The lock is simultane- During operation via Hi-O Technology™ bus with
ously connected via the IO module, detach the lock's grey connec-
Hi-O Technology™ bus. tion cable on the functionless unlocking control
input (follow separate instructions on the
lock).
The voltage has just Wait until the lock is ready for operation after a
been switched on on restart (follow separate instructions on the
the lock. lock).
The lock was discon- Deactivate Plug & Play via DIP switch 3
nected from the ("DIP switch", page 46).
Hi-O Technology™ bus
with Plug & Play mode
activated..
Problem, cause, solution