Zodiac NOMAD RIB ALU 2.7 Eignerhandbuch Seite 33

VIII DRAINAGE INSTALLATIONS
While boating, insert the caps into the sea cocks in position (2).
Water draining procedure:
When stopped: plug in position (1), then navigate in planing position (> 6 knots). Place parts
back in position (2) when the water is drained.
Once the boat is out of the water (on a tailor, hoist), plugs in position (1).
At a temporary mooring or in other situations where the boat is unlikely to take in large
amounts of water (heavy rain, breaking waves), place the parts in position (1) or (2).
For prolonged or risky mooring: cap out and a mooring awning.
POSITION (1): cap out
POSITION (2): caps inserted into the sea cocks 1
WARNING
IF THE BOAT TAKES IN LARGE AMOUNTS OF WATER FROM
THE OUTSIDE (HEAVY RAIN, WAKE,...) AND THE THROUGH-
HULLS ARE PLUGGED, THE BOAT RISKS BEING SUBMERGED
(SWAMPED). THE WATER TAKEN ON MAY THEN ACCUMULATE
IN THE BILGE AND MAKE THE BOAT MUCH HEAVIER CAUSING
IT TO LIE LOW IN THE WATER AND CAUSE SERIOUS DAMAGE
TO CERTAIN UNITS SUCH AS THE ENGINE OR THE ELECTRICAL
CIRCUITS.
Page 33 of 40
614764