Zodiac NOMAD RIB ALU 2.7 Eignerhandbuch Seite 26

V HANDLING YOUR BOAT
Before starting, refer to the Owner's Manual Volume I.
NOTE: Check that the tube is correctly inflated.
Remote control version (steering position)
1
Move the battery switch (not supplied) to "ON" to
provide voltage
3
Put the circuit breaker on and connect
it*
* Should the operator fall overboard, immediately shutting down the engine considerably reduces the
risk of serious or even deadly injuries caused by the boat's motion. Always properly attach both ends of
the emergency circuit breaker.
4
Control lever in neutral
WARNING:
YOU NEED TO HAVE A BATTERY CUT-OFF FOR REMOTELY CONTROLLED MOTORS
AND IT MUST BE LOCATED IN A LOCATION THAT IS ACCESSIBLE TO THE
OPERATOR AT ALL TIMES SO AS TO DISCONNECT ALL DEVICES FROM THE
BATTERY. CUT THE ENGINE BEFORE SETTING THE ON/OFF SWITCH TO THE "OFF"
POSITION.
DANGER!!!
TURN OFF THE ENGINE IMMEDIATELY AS SOON AS A SWIMMER COMES
CLOSE TO THE BOAT. A SPINNING PROPELLER REPRESENTS A SERIOUS INJURY
HAZARD.
SOME CONTROL HANDLES ARE NOT EQUIPPED WITH MECHANISMS THAT
LOCK THEM IN A NEUTRAL POSITION. BE CAREFUL TO NOT TRIGGER THE
CONTROL HANDLE UNINTENTIONALLY.
WARNING:
NEVER LEAVE THE STEERING POSITION UNATTENDED.
THE BOAT MAY MOVE SUDDENLY, HOLD ON SECURELY TO AVOID
FALLING.
WHILE BOATING ALWAYS MAINTAIN A SUITABLE LOOKOUT.
Page 26 of 40
2 Check that the supply sources (fuel or electricity are
open).
5
Actuate the engine starter
614764