Herunterladen Diese Seite drucken

Zodiac NOMAD RIB ALU 2.7 Eignerhandbuch Seite 23

Band 2 – teil 2

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 161
III-3 Pressure
The tube has 3 compartments. Each one should be at a pressure of 240 mb / 3.4 PSI.
This is the tube's correct pressure.
The ambient temperature of the air or the
water proportionally influences the
Tube internal pressure.
It is therefore important to be able to anticipate changes.
Check and adjust the pressure in the inflatable compartments (by inflating or deflating) in line with
temperature variations (especially when there are significant temperature variations between morning and
evening in areas that are particularly hot) and make sure that the pressure does not deviate from the
recommended pressure range (220 to 270 mb).
RISK OF PRESSURE LOSS
Example:
Your boat is exposed to bright sunlight on the beach (temperature = 50°C) at the recommended pressure level
(240 mb/3.4 PSI). When you put it in the water (temperature = 20°C), the temperature of the inflatable
compartments and the pressure inside them will fall in step (by up to 120 mb) and YOU WILL NEED TO REFLATE
to regain the millibars lost due to the difference in temperature between the ambient air and water.
It is normal to observe a drop in pressure at the end of the day when the outdoor temperature drops.
RISK OF OVERPRESSURE
Example:
Your boat is inflated to its recommended pressure (240 mb/3.4 PSI) at the start or the end of the day (low outside
temperature = 10°C). During the day, your boat is exposed to bright sunlight on the beach or on the deck of a
yacht (temperature = 50°C). Temperature inside the inflatable compartments will increase (up to 70°C) especially
with a dark colour tube, causing the initial pressure to double (480 mb). YOU WILL NEED TO DEFLATE to return
to the recommended pressure.
IN THE EVENT OF OVERPRESSURE
Release air by pressing the valve plunger
WARNING!!!
IF YOUR BOAT IS OVERINFLATED, THE PRESSURE WILL ABNORMALLY
WEAR THE INFLATABLE STRUCTURE WHICH MAY LEAD TO A BREACH
OF THE ASSEMBLY.
Page 23 of 40
TUBE
Ambient temperature
+1°C
-1°C
Tube internal pressure
+4 mb / 0.06 PSI
-4 mb / 0.06 PSI
614764

Werbung

loading