Werbung
Verfügbare Sprachen
Verfügbare Sprachen
h) LIGHTING THE BARBECUE BURNERS
In case of burn back (ignition under the burner cap) switch
the product off, allow it to cool down (approximately five
minutes), then reignite the appliance. If the problem
of burn back persists, then please contact your local
Campingaz
representative.
®
- Open the cooking lid.
- Make sure that the control knobs are in the "OFF"
position (
).
O
- Press and turn the adjustment lever counter-clockwise
and put it in a full flow position (
If your barbecue grill is equipped with a piezoelectric
igniter:
- Press immediately on the igniter button (
GB
clicks.
- If the burner does not ignite after 4 or 5 attempts, wait 5
minutes and then repeat the operation.
If your barbecue grill is equipped with an electronic
spark igniter:
- Press immediately on the switch (
occurs. Continue pressing for a few seconds until the
burner is lit.
- If the burner does not ignite after 4 or 5 attempts, wait 5
minutes and then repeat the operation.
Once the burner is lit, there are two ways of lighting
another burner:
•
Firstly, repeat the lighting operation described
above;
•
Secondly, light the burner to the right or left of the
first burner lit, then the other burners in turn by
turning the adjustment button to the full flow position
(
).
If the piezoelectric ignition or the electronic ignition doesn't
work, use the manual ignition (following paragraph).
i) LIGHTING THE BARBECUE MANUALLy
- Open the cooking lid.
- Make sure that the control knobs are in the "OFF"
position (
O
).
- Light a match and then bring it from the back of the
barbecue grill toward the burner
stainless steel burner
cast iron burner
).
) until it
). A burst of sparks
stainless steel burner
- Push the control knob in and turn it anticlockwise until it
is in the full flow position
j) EXTINGUISHING THE BARBECUE
Return the control knobs to the "off" position (O), then close
the cylinder valve.
k) LIGHTING THE SIDE STOVE
(depending on the model)
The stove may operate independently or in conjunction
with the grill burner. Before igniting the camping stove, be
sure that the lid is open and then flipped away.
Lighting:
- open the gas cylinder valve.
- check that there is no gas leak between the gas cylinder
and the stove.
- check the condition of the hose connecting the grill
burner to the stove. If there are signs of cracks, call our
After Sales Service to have it replaced.
- Open the valve of the camping stove (+ direction).
- If your barbecue grill is equipped with a piezoelectric
igniter:
Press on the igniter button located to the right of the
control panel and identified in the pictogram (
it clicks. Press 3 or 4 times if necessary.
- If your barbecue grill is equipped with an electronic
spark igniter:
Press immediately on the switch (
occurs. Continue pressing for a few seconds until the
burner is lit.
10
cast iron burner
.
(
)
) until
). A burst of sparks
Werbung
