Clearaudio Universal Bedienungsanleitung Seite 8

User manual / Bedienungsanleitung
2.2 Universal tonearm without VTA-Lifter:
Universal
Pic. 7: tonearm without
Mounting the aluminum clamping ring on a non-Clearaudio turntable:
To install the aluminum clamping ring on the turntable chassis, you will need to drill the required
holes. Please refer to the drilling template shown below (Picture 8) for the measurements to mark
the exact drilling holes.
Please be informed, that this drawing is not suitable for use as a mounting tool.
Use a 3.3 mm HSS drill bit, then cut an M4 thread into each hole using an appropriate tap cutting
tool. If the turntable chassis material is not suitable for cutting threads, please use a 4.5 mm HSS
drill bit to drill the holes through the material. In this case use standard bolts and nuts to fix the
arm base.
Please note:
This drilling template is only for
pivot to spindle for
Pic. 8: Mounting the aluminum clamping ring on a non-Clearaudio turntable
8
VTA-Lifter
Universal
Universal
12 inch in the technical data on page 13.
9 inch tonearms. You will find the the correct
© clearaudio electronic GmbH, 2018/11