Clearaudio Universal Bedienungsanleitung Seite 10

User manual / Bedienungsanleitung
Adjustment of the tonearm height without
By loosen the screws on the side of the mounting plate you can adjust the height of the tonearm.
The height of the tonearm is adjusted correct, when the upper side of the mounted cartridge is
parallel to the surface of the record (when the cartridge is lifted down).
Universal
3. tonearm adjustments
The now following adjustments require an already mounted cartridge on the headshell.
Therefore please follow the instructions in the user's manual of the cartridge manufacture.
Please handle with care!
3.1 Adjustment of the Tracking force
1.)
Set up one of the three (for
the bronze nut of the tonearm tube and tighten it on the bottom side.
Adjusting tracking force is accomplished by moving the counter weight towards or away from the
pivot point on the shaft.
Pic. 11: Adjusting tracking force
3.2 Azimuth adjustment (vertical needle-position in the groove)
2.)
The azimuth is already pre-adjusted, when the
If you need to change the azimuth, please loosen the screw on the side of the tonearm headshell.
Now you can change the azimuth.
After the adjustment is finished, lock the srew in the headshell again.
Pic. 12: Adjustment of the azimuth
10
VTA-Lifter
Universal
12") / five (for
Universal
:
Universal
9") delivered counterweights onto
Green arrowhead = slower anti-skating
Red arrowhead = stronger anti-skating
tonearm has left our factory:
© clearaudio electronic GmbH, 2018/11