PeakTech 6060 Bedienungsanleitung Seite 12

* The meter is suitable for indoor use only
* Do not store the meter in a place of explosive, inflammable substances.
* Opening the equipment and service – and repair work must only be
performed by qualified service personnel
* Measuring instruments don't belong to children hands.
Cleaning the cabinet
Prior to cleaning the cabinet, withdraw the mains plug from the power outlet.
Clean only with a damp, soft cloth and a commercially available mild household
cleanser. Ensure that no water gets inside the equipment to prevent possible
shorts and damage to the equipment.
1. Introduction
®
The model PeakTech 6060 high-precision DC regulated power supply has two
ways adjustable output. The two adjustable outputs can also be selected for
constant voltage or constant currant, designed in high stability and performance
circuit. In constant voltage state, the output voltage can be arbitrarily from 0 V
on the nominal range; and in the state of constant current, the output current
can be adjustable from 0 A on the nominal range. The two outputs can be
connected in parallel or in series, while the master used for voltage or current
adjustment. The maximum output voltage in series is double of independent's,
and the maximum output current in parallel is double too.
There are volt and Amp meters (or 3 digit LCD) for indicating each of the two
outputs with high accuracy. The one fixed way output 5 V voltage. Due to the
single chip integrated regulator, this output has good stability and ripple factor,
and has reliable overload protection to protect the unit against being damaged
whenever overload or short circuit.
The units features in small size, good performance, novel appearance and etc,
it is the ideal power supply unit for science investigation, college, factory,
electronic appliance maintenance and etc. This power source can be fitted into
19"-racks and can be used as "stand alone"-unit.
Permanent operations
This model of power supply provides 2 adjustable outputs for a maximum
current of 10 A, which can be connected in series or parallel, that means a
maximum output of 20 A DC in parallel.
This performance is designed only for short time applications and not for
permanent operations.
For longer lifetime it is recommended to use up to 75% of the maximum values
for permanent operation.
-11-