Werbung
Verfügbare Sprachen
Verfügbare Sprachen
INSTALLATION/CONNECTION
Connecting external components
Output terminals
When connecting to an external amplifier, connect its ground wire
to the car's chassis to avoid damaging the unit.
Front/Subwoofer output
For 3-way crossover: Mid Range/Woofer output
34
ENGLISH
Microphone input jack (page 14)
Installing the DAB antenna
Connect the DAB antenna to the DAB antenna jack. (Page 33)
• DAB antenna is supplied for
For details, see the following.
KMR-M505DAB
• For
, you need to purchase the DAB antenna separately.
For details, refer to the instruction manual supplied with the DAB antenna.
Caution
• The film antenna (F) is exclusively for use inside the vehicle.
• Do not install at the following locations:
– where it may block the driver's view.
– where it may obstruct the operation of safety devices such as air bags.
– on movable glass surfaces such as the rear hatch.
– at side of vehicle (e.g. door, front quarter window).
– on rear window.
• Signal strength will weaken when installed at the following locations:
– on IR reflecting glass or locations covered with mirror type glass film.
– where it overlaps with genuine radio antenna (pattern).
– where it overlaps with window heating wires.
– on glass that blocks radio signals (e.g. IR reflecting glass, thermal insulation glass).
• Poor reception may occur:
– due to noise when windscreen wiper, air conditioner, or motor is turned on.
– depending on the direction of the broadcast station with respect to the vehicle (antenna).
• Thoroughly wipe oil and dirt from the pasting surface with the supplied cleaner (I).
• Do not bend or damage the film antenna (F).
• It may not be possible to install on certain vehicles.
• Check the cable routing of the film antenna (F) and amplifier unit (G) before pasting.
• Do not apply any glass cleaner after pasting the film antenna (F).
.
Werbung
