Werbung
Verfügbare Sprachen
Verfügbare Sprachen
TROUBLESHOOTING
Symptom
Sound is being interrupted or
• Reduce the distance between the unit and the Bluetooth
skipped during playback of a
Bluetooth audio player.
• Turn off, then turn on the unit and try to connect again.
• Other Bluetooth devices might be trying to connect to the
The connected Bluetooth
• Check whether the connected Bluetooth audio player
audio player cannot be
controlled.
• Disconnect and connect the Bluetooth player again.
"NOT SUPPORT"
"NO ENTRY"/"NO PAIR"
"ERROR"
"NO INFO"/"NO DATA"
"HF ERROR XX"/
"BT ERROR"
"SWITCHING NG"
The Bluetooth connection
between the Bluetooth device
and the unit is unstable.
Remedy
audio player.
unit.
supports Audio/Video Remote Control Profile (AVRCP).
(Refer to the instructions of your audio player.)
The connected phone does not support Voice Recognition
feature or phonebook transfer.
There is no registered device connected/found via
Bluetooth.
Try the operation again. If "ERROR" appears again, check
if the device supports the function you have tried.
Bluetooth device cannot get the contact information.
Reset the unit and try the operation again. If this does not
solve the problem, consult your nearest service center.
The connected phones might not support phone
switching feature.
Delete the unused registered Bluetooth device from the
unit. (Page 18)
INSTALLATION/CONNECTION
Warning
• The unit can only be used with a 12 V DC power supply, negative ground.
• Disconnect the battery's negative terminal before wiring and mounting.
• Do not connect Battery wire (yellow) and Ignition wire (red) to the car chassis or Ground wire
(black) to prevent a short circuit.
• To prevent short circuit:
– Insulate unconnected wires with vinyl tape.
– Be sure to ground this unit to the car's chassis again after installation.
– Secure the wires with cable clamps and wrap vinyl tape around the wires that comes into
contact with metal parts to protect the wires.
Caution
• For safety's sake, leave wiring and mounting to professionals. Consult the car audio dealer.
• Install this unit in the console of your vehicle. Do not touch the metal parts of this unit during
and shortly after use of the unit. Metal parts such as the heat sink and enclosure become hot.
• Do not connect the
wires of speakers to the car chassis or Ground wire (black), or connect
them in parallel.
• Mount the unit at an angle of less than 30°.
• If your vehicle wiring harness does not have the ignition terminal, connect Ignition wire (red)
to the terminal on the vehicle's fuse box which provides 12 V DC power supply and is turned on
and off by the ignition key.
• Keep all cables away from heat dissipate metal parts.
• After the unit is installed, check whether the brake lamps, blinkers, wipers, etc. on the car are
working properly.
• If the fuse blows, first make sure the wires are not touching car's chassis, then replace the old
fuse with one that has the same rating.
31
ENGLISH
Werbung
