Werbung
Verfügbare Sprachen
Verfügbare Sprachen
BLUETOOTH®
BLUETOOTH — Connection
Supported Bluetooth profiles
– Hands-Free Profile (HFP)
– Advanced Audio Distribution Profile (A2DP)
– Audio/Video Remote Control Profile (AVRCP)
– Serial Port Profile (SPP)
– Phonebook Access Profile (PBAP)
Supported Bluetooth codecs
– Sub Band Codec (SBC)
– Advanced Audio Coding (AAC)
Connect the microphone
Microphone input jack
Adjust the microphone angle
Secure using cord clamps (not
supplied) if necessary.
14
ENGLISH
Rear panel
Microphone (supplied)
Depending on the operating system and the firmware version of your
mobile phone, Bluetooth features may not work with this unit.
Pair and connect a Bluetooth device for the first time
1
Press B SRC to turn on the unit.
2
Search and select the name of your receiver ("KMM-BT5 "/
"KMR-M5 ") on the Bluetooth device.
"PAIRING"
"PASS XXXXXX"
KNOB" appears on the display.
• For some Bluetooth devices, you may need to enter the Personal
Identification Number (PIN) code immediately after searching.
3
Press the volume knob to start pairing.
"PAIRING OK" appears when pairing is completed.
Once pairing is completed, Bluetooth connection is established
automatically. "BT1" and/or "BT2" indicator on the faceplate lights up.
• This unit supports Secure Simple Pairing (SSP).
• Up to five devices can be registered (paired) in total.
• Once the pairing is completed, the Bluetooth device will remain registered
in the unit even if you reset the unit. To delete the paired device, see
[DEVICE DELETE] on page 18.
• A maximum of two Bluetooth phones and one Bluetooth audio device can
be connected at any time.
However, while in BT AUDIO source, you can connect to five Bluetooth
audio devices and switch between these five devices. (Page 19)
• Some Bluetooth devices may not automatically connect to the unit after
pairing. Connect the device to the unit manually.
• Refer to the instruction manual of the Bluetooth device for more
information.
"Device name"
"PRESS"
"VOLUME
Werbung
