simu T5EHz Anleitung Seite 9

6
Programming a new (individual, group or general) control point
6.1- Open the memory of the receiver from the control transmitter:
- Press the PROG key of the transmitter for about 3 seconds. The motor
will run for 0,5 second in one direction and then in the other.
6.2- Confirm the operation from the new transmitter you want to
program:
- Press the PROG key of the transmitter for 1 second. The motor will run
for 0,5 second in one direction and then in the other.
- For group controls, repeat operations 6.1 and 6.2 for each motor in the group.
- For general controls, repeat operations 6.1 and 6.2 for each motor in the installation.
- To delete an transmitter from the memory of a motor, perform operations 6.1 with a programmed transmitter, then per-
form the operation 6.2 with the transmitter to be deleted.
7
Recording / controling / deleting intermediate position
Recording:
- Move the motor to the wanted
position.
- Press 5 seconds on the "stop" key.
The motor will run for 0,5 second in
one direction and then in the other.
Deleting :
- Position the motor on the intermediate position. Press 5 seconds on the Stop key, the intermediate position is deleted.
8
Re-adjustment of end limits and modification of the rotation direction (in user mode)
The re-adjustment of end limits is automatic every 60 cycles (during 4 cycles) or after a power supply failure
for the following installation U P end limit, mounting A and C, DOWN end limit, mounting A and B.
8.1- Re-adjustment of UP end limit (mounting B and D only):
1
1- Move the motor to the UP end limit previously adjusted in §4.3 with the UP key.
2- Press simultaneously for 5 seconds the UP and DOWN keys. The motor will run for 0,5 second in one direction and
then in the other direction.
3- Adjust the new position with the UP and DOWN keys.
4- Confirm the new position by pressing 2 seconds the STOP key. The motor will run for 0,5 second in one direction and
then in the other direction. The new end limit is memorized.
8.2- Re-adjustment of DOWN end limit (mounting C and D only):
1
1- Move the motor to the DOWN end limit previously adjusted in §4.3 with the DOWN key.
2- Press simultaneously for 5 seconds the UP and DOWN keys, The motor will run for 0,5 second in one direction and
then in the other direction.
3- Adjust the new position with the UP and DOWN keys.
4- Confirm the new position by pressing 2 seconds the STOP key. The motor will run for 0,5 second in one direction and
then in the other direction. The new end limit is memorized.
Control:
- Press the "stop" key for 0,5
second. The motor runs to
the intermediate position.
5s
2
5s
2
5s
1
PROG ≥ 3s.
2
PROG < 1s.
3
3
>>
>>
0,5s
4
2s
4
2s
EN 4/5