Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3. Fault rectification
for the user and qualified installer
Fault
No hot water despite the hot water
valve being fully opened.
Poor jet formation, fitting spurts
when tap is turned on.
Fitting drips during heating up
process.
Fitting keeps dripping after being
turned off.
4. Environment and recycling
Dispose of packing material and appliances
The dispose of the packing material and the
appliances must be done according to the lo-
cal recycling laws and regulations.
Cause
No electricity supply.
Jet regulator blocked with limes-
cale.
Heater installed without anti-drip
function.
Anti-drip function of the "SNU 5 SL
anti-drip comfort" defective.
Due to the design type, residual
water is running out of the fitting
outlet.
Rectification
User/qualified installer: Check the fuses in the house installation.
User/qualified installer: Clean the jet regulator of the fitting and replace it if
necessary (see 1.3 Care/Maintenance).
Normal occurrence with conventional small heaters without anti-drip func-
tion. Dripping will stop when the heating up process has been completed.
Qualified installer: Replace heater
For guarantees please refer to the pespective
terms and conditions of supply for your country.
should be carried out by a qualified installer.
The company does not accept liability for
failure of any goods supplied which accor-
dance with the manufacturer's instructions.
5. Guarantee
The installation, electrical connection
and first operation of this appliance
9
Werbung
