Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Collomix GmbH
85080 Gaimersheim
Functionality
The machine consists of a mobile frame with a permanently mounted mixing bucket made of
steel sheet. A 3-arm mixing tool rotates in the mixing drum around a central drive axis.
Ideally, the mixer is first filled with the dry material and then the necessary amount of water is
added to the running machine
The materials are usually mixed and ready for use within three to five minutes. Observe the
information of the material manufacturer and check the mixing quality using a test mixture.
Open the segment slidegate at the bottom of the bucket to empty the mixer during operation.
The rotating mixing tool conveys the material to the discharge chute.
Transport information
The machine is delivered on a pallet without wheels. Observe the assembly instructions.
The empty weight of the machine amounts to 131 kg (TMX 1000) /138 kg (TMX 1500).
The machine must always be sufficiently secured against tilting and rolling away using several
transport straps for vehicle transport. Non-secured loads can result in serious personal injury
and material damage.
Lash the machine via the lashing eyes with lashing strips of a sufficient size.
The lashing eyes are not suitable for transportation by crane.
Assembly
The following tools are required for initial assembly:
1 x open-end wrench SW 10; 2 x open-end wrench SW 17
Removal of the transport lock:
Loosen the screw connections of the four feet on the pallet. (Open-end wrench SW 10 )
Adjusting the height:
Risk of tipping! Seek the assistance of a second person in this regard.
Loosen the 4 screws on the two front feet using two open-end wrenches SW 17. Tilt the machine
until it becomes possible to insert the 4 screws into the upper bores. Then tighten the screws
again.
ATTENTION!
ATTENTION!
EN
TMX 1000
TMX 1500
19
Werbung
