Collomix TMX 1000 Originalbetriebsanleitung Seite 17

Collomix GmbH
85080 Gaimersheim
Do not connect the device to standard electrical sockets. Always connect the devices via a residual
X
current device (RCD) with a response current of 30 mA or less.
If a cable reel is used, the cable must be fully unwound. There is a risk of a cable fire due to heating.
X
A loss of power may occur as well, leading to the undervoltage protection being triggered.
Repairs on electrical components may only be carried out by a recognised electrician, complying
X
with the local regulations.
Electrical operating equipment must be subjected to a regular inspection by an electrician (accor-
X
RCD 30mA
ding to German Social Accident Insurance DGUV 3).
Keep the device away from rain and moisture. Water penetration into an electrically operated
X
machine increases the risk of an electric shock.
Always pull the mains plug during non-operation, maintenance or when replacing the mixing tool.
X
Do not disconnect the plug from the socket by pulling on the cord. Protect the cable against heat,
X
oil, bending and sharp edges.
Check the cable for damage or defects prior to use.
X
Wait, until the device and/or tool comes to a complete standstill. Rotating tools can get stuck and
X
cause injuries or damage.
Only remove material samples with the device at standstill.
X
Acute risk of accidents and injuries if the safety functions are disabled on purpose. In this case, the
X
warranty shall become void.
Check the machine regularly for flawless function and damage. Do not put the machine in opera-
X
tion with damaged or defective safety components.
Do not clean the machine using a high-pressure cleaner or hose – risk of electric shock!
X
Do not expose the machine to any rain, not even during transportation.
X
Observe the processing and safety information of the manufacturer for the material to be mixed.
X
The machine must be firmly lashed in at least three directions for vehicle transport.
X
Only operate the machine with the TMX mixing tool that is suitable for the machine.
X
Only use original spare parts. The use of third-party spare parts may lead to accidents of the user.
X
The manufacturer shall not be liable for any resulting damage.
EN
TMX 1000
TMX 1500
17