Oase ProMax ClearDrain 7000 Inbetriebnahme Seite 15

Installing the pump
 G
• Install the pump in a horizontal and stable position in the water.
• If it needs to be lowered into a well or a shaft, fasten a rope to the handle. Do not carry it by
the power connection cable.
• Install the pump such that it does not take in dirt particles with a size >5 mm, which would
block the intake. Install the pump in a raised position if necessary.
• ProMax ClearDrain 7000: Ensure that the float switch can always move freely.
Operation
WARNING
Risk of severe injuries or death by electric shock.
 Only operate the pump if no persons are in the water.
Disconnect all electrical devices in the water from the power supply before reaching into the

water.
NOTE
The pump is not suitable for continuous operation. Continuous operation will reduce the pump
service life accordingly.
Switching on the unit
• Insert the power plug into the socket.
– The pump is ready for operation.
– The pump will start up as soon as the level of the water reaches the switch-on height.
Switching off the unit
• Disconnect the power plug.
– When the pump is switched off, residual water in the hose may flow back and out of the
pump intake.

After using the pump, rinse it with clear water.
EN
15