Oase ProMax ClearDrain 7000 Inbetriebnahme Seite 13

The following restrictions apply to the unit:
• Not suitable for salt water.
• Never use for pumping dirty water/waste water.
• Not suitable for drinking water.
• Do not connect to the drinking water supply.
• Do not use for long-term operation (e.g. continuous recirculation of the water in a pond).
• Do not use for commercial or industrial purposes.
• Do not use in conjunction with chemicals, foodstuff, easily flammable or explosive substances.
Installation and connection
Connecting the pressure hose
An optimum flow rate is achieved with the largest possible hose inside diameter.
How to proceed:
 A
1. Adapt the stepped hose adapter to the hose diameter
2. Connect the hose to the stepped hose adapter.
– Secure the hose with a hose clip.
3. Screw the stepped hose adapter onto the pump outlet.
Automatic mode ProMax ClearDrain 7000
 B
When the water level rises, it lifts the float switch until the switch-on point is reached and the
pump switches on.
When the water level drops, the float switch lowers until the switch-off point is reached and the
pump switches off.
• Push the float switch cable into the cable clip.
– The shorter the cable between the float switch and the cable clip, the lower the switch-on
point and the higher the switch-off point.

To ensure fault-free function, ensure that the cable length between the float switch and the
cable bracket is at least 100 mm.

The minimum residual water height is only reached in manual mode.
EN
13