Helios AIR1-CO DX-Serie Montage- Und Betriebsvorschrift Seite 53

Installation and Operating Instructions
NOTE
NOTE
m
DANGER
nm
m
CAUTION
Change-over-unit AIR1-CO DX
2. Clean the condensate tray with a cloth (see Fig.44
3�1�3 Cleaning the change-over-unit DX
For cleaning the change-over-unit DX carefully remove the service door (see Fig.41
over-unit DX.
The fins must not be bent!
The must be regularly checked for dirt and dust deposits. If there is dirt and dust on the
– change-over-unit DX
, these can be removed with water.
over-unit DX
– The cleaning can be carried out with water. Household cleaning agents can be used.
– The fins must not be bent!
– When cleaning, ensure that the
Allow the change-over-unit DX to dry before installation
3�2 Standstill and disposal
m
Danger to life due to electric shock!
When dismantling, live parts can be exposed, which can result in electric shock if touched�
- Before dismantling, isolate the unit from the mains power supply and protect against being switching on again!
Dispose of all components and disused operating materials in an environmentally-friendly manner in accordance with
the local codes, practices and environmental regulations.
An authorised specialist waste processing company must dispose of the unit or the individual components. The appo-
inted contractor must ensure that:
– the components are separated according to material types.
– the used operating materials are sorted and separated according to their respective properties.
Cooling agents contain substances which may be dangerous and harmful to the environment� These must not
get into the environment�
The corresponding operator guidelines applicable on-site must be observed and used. Please think of the environ-
ment, you can make a significant contribution to the environmental protection by returning batteries and accumula-
tors!
).
Fig�44
is not damaged mechanically or chemically
change-over-unit DX
!
26
Carefully remove the change-
).
change-
.
EN