Helios AIR1-CO DX-Serie Montage- Und Betriebsvorschrift Seite 44

Installation and Operating Instructions
EN
NOTE
Change-over-unit AIR1-CO DX
2. Remove the temperature sensor from the marked position in the supply air duct of the AIR1 unit (see Fig.19).
3. Insert the temperature sensor on the supply air side of the change-over-unit DX and fasten to the metal bracket with
a cable tie (see Fig.20).
AIR1-CO DX L
4. Attach the change-over-unit DX to the AIR1 unit. Connect the free temperature sensor plug from the AIR1 unit to the
change-over-unit DX (see Fig.21).
Only the direct mounting of the AIR1-CO DX to the AIR1 ventilation unit is permitted!
AIR1-CO DX L
AIR1-CO DX R
AIR1-CO DX R
Fig�21
17
Fig�19
Fig�20