Whirlpool WCTH 63F LEB X Betriebsanleitung Seite 25

END-OF-LIFE DISPOSAL
This device is marked in compliance with the European Directive 2012/19/EC - UK SI 2013 No.3113, Waste Elec-
trical and Electronic Equipment (WEEE).
Make sure that this product is disposed of correctly. The user helps prevent potential negative consequences for the
environment and for health. The symbol on the product or accompanying documentation indicates that this product should
not be treated as household waste but should be handed over at a suitable collection point for the recycling of electrical and
electronic equipment. Dispose of it in accordance with local regulations for waste disposal. For further information about the
treatment, recovery and recycling of this product, please contact your local authority, the collection service for household
waste or the shop from where the product was purchased.
The packaging material is 100% recyclable and is marked by the recycling symbol
REGULATIONS
Equipment designed, tested and manufactured in compliance with safety regulations: EN/IEC 60335-1; EN/IEC 60335-2-
31, EN/IEC 62233. Performance: EN/IEC 61591; ISO 5167-1; ISO 5167-3; ISO 5168; EN/IEC 60704-1; EN/IEC
60704-2-13;EN/IEC 60704-3; ISO 3741; EN 50564; IEC 62301. EMC: EN 55014-1; CISPR 14-1; EN 55014-2; CISPR 14-2;
EN/IEC 61000-3-2; EN/IEC 61000-3-3.
OPERATING ERRORS
If something does not seem to be working, perform the following simple checks before contacting the Service Centre:
• If the hood is not working:
Check that:
-There is no power failure
-A speed has been selected
• If the hood has poor performance:
Check that:
-The selected motor speed is sufficient for the amount of fumes and steam released.
-The kitchen is sufficiently ventilated to allow an air intake.
-The carbon filter is not worn out (hood in filtration version).
• If the hood has switched off during normal operation:
Check that:
-There is no power failure.
-The safety cut-off device has not tripped.
In the event of any malfunctions, disconnect the appliance from the electrical power supply for at least 5 seconds by
unplugging it and then reconnect it, before contacting the Service Centre. If the malfunction persists, contact the Service
Centre.
16