Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Before starting the machine check the correspondence between voltage and
frequency according to the data mentioned on the identification plate.
Voltage differences from + 6 % and – 10 % are allowed.
The grinder is made in protection class I.
Only use extension cables with a sufficient cross-section. A cross-section
which is too small could cause a considerable drop in performance and an
overheating of machine and cable.
Switching on and off
4
Attention!
In case of every automatic stop of the machine or mains
!
failure, the concrete grinder has to be switched OFF
immediately by pressing the ON/OFF switch. Consequently,
you can avoid an unintentional restart of the machine
(physical hazard).
7
Electrical Connection
Put the plug in the mains.
Tilt slightly the machine, so that the grinding
wheel runs free when switching on.
Switch ON / OFF switch (4) to "I".
Before switch off tilt slightly the machine again
and switch the ON / OFF switch to "0".
Before put down the machine, wait until the
grinding wheel stops.
21
Werbung
