Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ENGLISH
MAINTENANCE
Safe and efficient use can only be achieved if the appliance is
properly installed and maintained. It is your responsibility to ensure
that the appliance is maintained regularly. Parts that have been
used and/or damaged must be replaced before the appliance is
used again. The appliance should only be used and stored indoors.
Long-term exposure to weather and temperature/humidity changes
can have a serious impact on the electrical components and moving
parts of the unit. Always unplug the power cord from the unit before
cleaning or servicing it.
Daily maintenance
•
Clean and remove sweat and moisture after each use.
•
Check that the unit is free of dust and dirt.
•
Do not use aggressive cleaning agents and keep the device
away from moisture.
Semi-annual maintenance
•
Inspect all bolts and nuts connected to the moving parts of the
unit. Tighten bolts and nuts as necessary and appropriate.
•
Check the mobility of moving parts and components of the unit.
Use silicone spray if necessary and appropriate.
We recommend the following:
•
Clean the unit after use.
•
Use a dry cloth to clean the control panel and the areas around
the on/off switch.
•
Use a soft, clean cloth and detergent to remove stubborn marks
and dirt from the unit.
•
Store the unit in a safe, dry place away from heat and water.
CAUTION!
•
Repairs must be carried out by a professional technician,
unless otherwise specified by the supplier or manufacturer.
Cleaning
General cleaning of the unit will extend its life. Keep the appliance
clean by dusting it regularly. Regular maintenance will prolong the life
of your appliance and prevent injuries! For more information, please
visit https://www.virtufit.nl/service/faq/
CAUTION!
Wear clean shoes to reduce the risk of soiling the
machine. At least once a year, remove the cover to remove dust.
Battery
AAA BATTERIES
The display uses AAA batteries, which are replaceable on the back of
the display. The batteries must be inserted correctly.
If the screen is unreadable or only parts of the image work, proceed
as follows:
•
Remove the batteries and wait 15 seconds.
•
Replace the batteries correctly.
Tips on using the battery
•
Remove the batteries from the screen when they are empty or
when the camera will not be used for a long period of time.
•
Do not recharge, disassemble or dispose of batteries in fire.
•
Pay close attention to the + and - when inserting the batteries.
When replacing batteries, it is recommended to replace all
batteries, do not mix old and new batteries.
•
It is recommended to use alkaline batteries, they have a longer
life than normal batteries.
•
Batteries should be replaced when the display loses brightness
or stops showing.
Battery replacement
•
If the display is not accurate, it is recommended to replace the
batteries.
•
Use 2 x AAA batteries for power.
TROUBLESHOOTING
The display does not show any values: Check that the sensor and
console cables are properly attached and undamaged. If this does not
solve the problem, carefully bend the sensor.
Exercise bike squeaks: Check that all bolts and nuts are tight. If
necessary.
Ticking noise when pedalling: This may be caused by one of the
pedals. Remove the pedal(s) and mount it (them) correctly on the unit.
Tighten the pedal(s) firmly. If this does not solve the problem, contact
the supplier.
NOTE!
The "R" (right) pedal must be mounted clockwise and the "L"
(left) pedal must be mounted counter-clockwise.
10
Werbung
Kapitel
Inhaltsverzeichnis
Fehlerbehebung
