Skoda ALU Bedienungsanleitung Seite 9

Decorative door sill covers – ALU
The accessories are intended for professional fitting. ŠKODA AUTO recommends that they are
fitted in an authorised workshop.
Component index for the side door sill cover set – fig. 1
Component
Front side door sill cover
Fitting instructions
Note
The templates for correctly positioning the side door sill covers (fig. 2) on the vehicle sills are
not included in the set and must be ordered separately from the ŠKODA Genuine Accessories
range using order no. 657 071 718.
Please note: Use the openings in the templates to mark where the side
door sill covers are to be positioned on the vehicle sills. These are
indicated by black arrows on a white background. Make sure that you
position the correct template carefully on the vehicle sill and draw the
line along the outer edge of the opening.
Important fitting information
In order to ensure that the side door sill covers are properly adhered to the vehicle, the ambient
temperature, the vehicle temperature and the temperature of the components to be fitted
must be between 18 and 30 °C. Protect the components from direct sunlight.
How to adhere the side door sill covers
- 3 -
- Thoroughly wash the vehicle sills with mild soapy water and rinse them with clean water.
Then degrease them with a suitable cleaning agent. Leave to dry for approximately
10 minutes.
- 4 -
- Use the templates to correctly position the side door sill covers on the vehicle sills. Always
position the correct template (left/right) on the vehicle sill, as shown in the figure.
- The templates for the side door sill covers perfectly follow the contours of the vehicle sill and
the A-pillar.
- Use a suitable felt-tip pen to make marks where the door sill covers are to be positioned
on the vehicle sills. Make sure that you draw the line along the outer edge of each of the
openings – the openings are indicated by black arrows on a white background.
- 5 -
- Remove the template.
- Place the door sill cover onto the vehicle sill, lining it up with the marks you have made. Check
that the door sill cover is positioned correctly in relation to the other components on the
vehicle (door seal, recess in the sill, etc.).
Quantity Item
1 + 1
1
A
9
EN