Werbung
Verfügbare Sprachen
Verfügbare Sprachen
The motor cable is mounted at the angle plug of the ser-
vo motor and tightened by hand. The angle plug can be
turned.
2.4 r
Ating dAtA
Max. tool shaft Ø
Concentricity
Tool holder
IP protection motor
Belt drive transmission
s
t
n086-3-F
erVOmOtOr
ype
Motor output rating
Nominal motor current
Torque at motor speed 3500rpm
Torque at max. motor speed 7000rpm
Weight URS-01/RGS-01
s
t
ln086-4-e
erVOmOtOr
ype
Motor output rating
Nominal motor current
Torque at motor speed 2500rpm
Torque at max. motor speed 5000rpm
Weight URS-01/RGS-01
2.5 O
perAting cOnditiOns
Temperature range during operation: +10 to +50°C. Max-
imum relative air humidity: 90% at +30°C, 65% at +50°C.
The partly completed machinery must be protected
against direct spray and/or pressurized cutting fluids.
3. h
aNDlINg
3.1 p
Artly cOmpleted mAchinery
3.1.1 i
nserting the cOllet chuck
Choose the collet chuck matching the tool shaft diameter.
Introduce the collet chuck under an angle into the clamp-
ing nut. The eccentric on the clamping nut must then en-
gage in the collet chuck groove. Insert the collet chuck
into the spindle, and tighten it with the special key.
13mm
3.1.2 i
0.02mm
ER20
IP 65
i=1:1
0.94kW
4.7A
3.25Nm
2.8Nm
5.1kg/6.7kg
With the collet chuck inserted, loosen the tension nut un-
1.5kW
til the tool shaft can be introduced into the collet chuck.
6.4A
Tighten the tension nut. In doing so, hold the spindle firm-
3.8Nm
ly in place with the flat key.
2.9Nm
6.0kg/7.6kg
3.1.3 t
Type ER 20 1.5-6.5
Type ER 20 7.0-13.0
/o
PERaTIoN
3.2 c
In order to access motor controls, you will need a control-
ler kit or a SUHNER Power Hub with regulator.
3.3
nserting And tensiOning the tOOl
Always remove the key after use!
ightening tOrque
The tightening torque of the tension nut can not be
more than 25% above the recommended values.
Type ER 20 1.0
OntrOl
nOtes On OperAting sAFety
Use the attachments intended for each applica-
tion. Do not trim attachments for applications they
have not been designed for.
16Nm
28Nm
28Nm
23
Werbung
