Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4 Function
4 Function
4 Function
4 Function
4 Function
The water to be treated flows through the stainless steel radiation chamber (1 1 1 1 1 ).
EN
EN
EN
EN
EN
The UV emitters generate UVC rays at a wavelength of 254nm, which is
particularly effective for disinfection. This UVC radiation kills the germs
in the water safely.
During the residual ozone destruction process, the UVC radiation at a
wavelength of 254nm degrades the ozone dissolved in the water highly
effectively.
The volume flows specified in the technical data refer to the residual
ozone destruction process.
Disinfection is ensured provided that these volume flows are maintained
and UV transmission is greater than 90% / 10cm.
UV transmission of 90% / 10 cm can be expected for demineralized
water.
Residual ozone destruction: Elimination of max. 0.2 ppm ozone at 98%.
The unit is controlled/monitored by the processor-controlled electronic
system which is integrated in the switching cabinet (3 3 3 3 3 ).
See UV
See UV
See UV
See UV-Control II installation and oper
See UV
-Control II installation and operating instr
-Control II installation and oper
-Control II installation and oper
-Control II installation and oper
The UVC sensor monitors emitter aging, the radiation intensity and any
deposits formed on the emitter protection tubes.
Note
Note
Note
Note
Note: The UVC emitter performance is temperature dependent. Small
variations in the display are normal for different water temperatures or
heating while idle.
1 8
1 8
1 8
1 8
1 8
ating instructions
ating instr
ating instr
ating instr
uctions. . . . .
uctions
uctions
uctions
5 Installation conditions
5 Installation conditions
5 Installation conditions
5 Installation conditions
5 Installation conditions
General
General
General
General
General
Observe all applicable local installation regulations, general guidelines
and technical specifications.
Installation site and environment
Installation site and environment
Installation site and environment
Installation site and environment
Installation site and environment
The installation site must be free of frost and kept free of chemicals,
paint, solvents and fumes. Neither the ambient temperature nor the
radiation temperature may exceed 40°C in the immediate vicinity.
If no floor drain exists, a separate safety device (hydrostop) must be
used.
There must be at least 1.0m of clearance above the unit to facilitate
emitter replacement.
Operation
Operation
Operation
Operation
Operation
In order to guarantee that the unit operates properly and safely, you
must consult with specialized technicians before installation. During
the consultation, the rated transmission of the water to be treated is
determined and the operating parameters required are set.
The maximum 0
-incoming concentration should not exeed 0,2 ppm.
3
Werbung
