Kerbl 70550 Bedienungsanweisung Seite 16

1 2
7. Bringing into operation
CAUTION!
Risk of physical injury and material damage if used incorrectly!
• Installations on the 230 Volt network must only be carried out by qualified electricians.
• Route the cable to the automatic chicken door with protection so that the animals are unable to reach it.
• If the device is supplied with power from the power pack, the battery is not used. However you should replace the battery at regular intervals
since otherwise there is a risk that the battery may leak. Spent batteries and the device itself
should be disposed of properly without delay.
• First close the housing before connecting the mains plug to the socket! Always disconnect the
mains plug from the socket if you are opening the housing (for example also if you want to insert
the light sensor).
To supply the device with the power it requires, connect either the power pack to the device
and plug it into a 230 Volt mains socket or insert the battery into the device. You can also choose
both supply methods to be prepared for a power failure. Connect battery connection wires to
the corresponding plug.
Open and close the door a few times to ensure it is operating smoothly. You can now make
the relevant settings, as described below.
8. Operation
8.1 Time setting
To set the current date and time, press the OK button for around 3 seconds. The year
currently set starts to flash. Change the value using the arrow buttons and confirm the
year setting with the OK button. The date then flashes with the month and day. Change
the value of the date using the arrow buttons. The example shown is 08.06.
The next confirmation takes you to the setting for the current time.
Change the value of the time using the arrow buttons. Exit the Settings menu with the Menu button.
8.2 Automatic opening and closing with the timer switch
You can set an opening and closing time for week days (Monday - Friday) and weekends (Saturday + Sunday). Please note that the door will
only open or close at the specified times if automatic mode is active.
8.2.1 Setting the opening and closing times
To set the times, press the Menu button for around 3 seconds. The opening time for week
days setting appears. The opening time is indicated by the
the display. Use the arrow buttons to select your desired opening time and confirm the
input with the OK button.
The closing time for week days setting then appears. The closing time is indicated by
the symbol on the right side of the display. Use the arrow buttons to select your desired
closing time and confirm the input with the OK button.
3
symbol on the right side of
16
4
Month Day
5