Servonaut SMR Bedienungsanleitung Seite 25

SMR and standard radio
For the control channel a three way switch is
required. To activate the horn the radio has to be
set that it sends a rate between 80% and 100%
when the "horn-button" is pressed. Ignition is on
the other side and the radio needs to be set that it
sends a rate between -80% and -100% when
pressed.
For each hydraulic channel that should produce
sound a free mixer is required. This mixer has to
be adjusted that it sends approx- +/-40% of the
hydraulic channel to the control channel of the
SMR. In case several hydraulic channel are mixed
together the sum of all values should not exceed
40%.
If the horn sounds or the engine sound
stops while using hydraulic functions
please reduce the mixer amount.
LED-Codes
Two LEDs show the status of your SMR.
LEDs
green flashes repeatedly
3x red then
1x, 2x or 3x green
Meaning
standard, every-
thing ok
error codes -
please contact Ser-
vonaut for more
information
Manual SMR 25