Servonaut SMR Bedienungsanleitung Seite 18

SMR Sound Module
The SMR is programmed with real sounds of a
wheel loader and a chain dozer. It plays the
sounds with high quality and realistically adapted
to the movement of your scale model.
What's in the box
sound module SMR
·
volume pot
·
· circuit jumper
Features
two genuine engine sounds
·
three different horns
·
three different reverse alarms
·
dynamically changing sound replay
·
compressed air and hydraulic sounds
·
no extra battery necessary, can directly be
·
powered from main battery
· one RC input channel to control engine RPM
· a second input to control starter, horn and
additional hydraulic sounds
18 Manual SMR
Functionality
After switching power on you will hear some
typical sounds like door slamming and a beep
from the ignition system.
Starter and horn work just like on every other
servonaut sound module. You need a dedicated
receiver channel to control them. On the SMR this
channel is also used to trigger hydraulic sounds.
You need a free mixer on your radio for every
channel that controls a hydraulic vent. Mix about
40% of this channels to the sound channel of the
SMR. Use a switch with three positions and 100%
rate on the same sound channel to control starter
and horn.
To get familiar with this feature you may
connect the SMR sound channel with a
proportional stick channel of your radio.
You may use the SMR without any mixer
in your radio, but then you won't have
hydraulic sounds.
Starting and stopping the engine sound is
only possible while the engine is in idle
state.