Werbung
2
•
USE
When the automatic cook function starts
"A" indication flashes with desired power
level on the display.
- SWITCHING THE AUTOMATIC COOK
START FUNCTION OFF
After at least 10 seconds have elapsed
since the beginning of the automatic
cook start function:
1 The hot plate must be selected.
2 Press touch key
reaches level 9 and the automatic cook
start function will be deactivated.
2.10 TIMER FUNCTION
This function makes it easier to cook, as
you
do
not
need
throughout the process: the timed hot
plate(s) will switch off automatically after
the set time has lapsed. There is a
separate timer for each hot plate, which
allows all of the hot plates to be timed
simultaneously.
With these models you can use the clock
as a timer for the hotplates for times
ranging from 1 to 99 minutes. All the
cooking areas can be programmed
individually
and
manner.
TIMING ONE HOTPLATE
1 The cooking zone to be timed must
be selected.
2 Select a power level for the hotplate
from 1 to 9 using the touch keys
(5/4).
3 Press clock touch key
indicator (12) will display 00. Timed hot
plate display (11) will flash.
4
Immediately
cooking time between 1 and 99 minutes,
by using the touch keys
(5) till the indicator
to
be
present
in
a
simultaneous
or
(10). Timer
afterwards,
enter
or
(5/4).
When the power indicator (3) stops
flashing, it will start to count down the
time automatically. The respective timed
hotplate
disolay (11) will continue
flashing.
When the clock reaches 01, it will switch
from counting down minutes to seconds.
Once the selected cooking time has
elapsed, the heating zone being timed is
turned off and the clock emits a series of
beeps for several seconds. The timer
indicator will display a flashing 00 beside
the hotplate that has been disconnected.
If you wish to time another hotplate at
the same time, repeat steps 3 and 4.
If the heating zone turned off is hot, its
indicator displays an H or otherwise an
0. To turn off the audible signal touch
any sensor.
CHANGING THE PROGRAMMED TIME
To change the progrmmed time, you
must press the touch key of the timed
hotplate (2) to select it and then the
clock
(10). You may then read and
change the time.
DISCONNECTION OF THE TIMER
If you want to stop the timer before the
programmed time is up
1 First select the hotplate and then
press clock touch key
2 Use the touch key
a
time to 00. The clock is cancelled.
28
(10).
(4) to recude the
Werbung
