Scheppach GS55 Originalbetriebsanleitung Seite 26

14. Troubleshooting
The table below contains a list of fault symptoms and explains what you can do to remedy the problem if your equipment
fails to work properly. If the problem still persists after working through the list, please contact your nearest service work-
shop.
Fault
The motor doesn't start.
The motor doesn't do
anything, the safety
default switches on.
The motor is overloaded
the safety default
switches on.
The shredder intake is
diminished, reduced
cutting capacity.
Excessive vibrations/
noise
26 | GB
Possible cause
The upper housing unit is not properly
closed.
The extension cable is defective.
No current is coming out of the outlet.
The switch is defective.
The motor is defective, the capacitor is
defective
Shredder material is obstructing the
blade disc.
The extension cable has an insufficient
cross section
The cable between the power system
connection and the shredder is too long.
The quantity of wet shredded material is
too high.
The blade and output areas are clogged.
The blade is dull.
The cable between the power system
connection and the shredder is too long.
The blade is either dull or worn out.
Blade nut/bolt loose
Cutting blade damaged
Machine damaged internally
www.scheppach.com
Remedy
Screw in the safety thoroughly
Exchange the extension cable or repair it.
Check the mains fuse.
Check/change
Check/change
Pull the main plug, open the housing and
clean it out.
Choose an extension cable with a larger cross
section
Create the shortest possible way between the
power system connection and the shredder.
Select a smaller quantity of shredded material.
Now and then, include dry shredding material
Pull the main fuse, open the housing and
clean it out.
Resharpen or change
Choose an extension cable with a larger cross
section.
Turn blade, sharpen blade or replace entirely.
Tighten blade nut/bolt
Replace blade
Contact Service Agent