Transmission Test - Danfoss CF-RC Benutzerinstruktion

Instruction CF-RC Remote Controller

3. Transmission Test

Initiate a transmission test on the Remote Controller
From the start-up screen, activate the:
Menu
Setup
Link test
Link test menu to activate a test of the wireless transmission between
the Master Controller and the Remote Controller. The status of the link
test will be displayed right after the test has been carried through.
If the link test is not successful:
• Try to relocate the Remote Controller in the room
• Or install a Repeater Unit (CF-RU, see fig. 5 c), and place it between the
Master Controller and the Remote Controller
Note: The link test may take a few minutes depending on the size of the
system

VI.UH.M3.80
Produced by Danfoss Floor Heating Hydronics 02.2006