Danfoss CF-RC Benutzerinstruktion Seite 19

Instruction CF-RC Remote Controller
In the Service menu, activate the Standby temperature function
with OK in order to set a fixed room temperature for all the Room
Thermostats to 5 – 5°C when the Global standby input is activated on
the Master Controller (see instruction for Master Controller, CF-MC for
installation details).
Contrast:
Here you can adjust the contrast of the Remote Controller display.
Link test:
Activates a link test to the Master Controller to test the wireless trans-
mission to and from the Remote Controller (see ).
Identify Master Controller:
This function enables you to identify one specific Master Controller in a
system of up to three Master Controllers. When this function is activat-
ed, the Master Controller, whose identity you wish to reveal, will flash
all the output LEDs from  to 0 and back again several times for easy
identification.

VI.UH.M3.80
Produced by Danfoss Floor Heating Hydronics 02.2006