GreenWorks G24LT30K2 Bedienungshandbuch Seite 9

4. Tighten the screws.
3.4 ATTACH THE AUXILIARY HANDLE
Figure 4.
1. Remove the knob from the handle.
2. Attach the auxiliary handle on the shaft.
3. Set the auxiliary handle in the comfortable position.
4. Put the bolt through the holes.
5. Tighten the auxiliary handle with the knob.
3.5 INSTALL THE BATTERY PACK
Figure 5.
WARNING
• If the battery pack or charger is damaged, replace
the battery pack or the charger.
• Stop the machine and wait until the motor stops
before you install or remove the battery pack.
• Read, understand, and follow the instructions in
the battery and charger manual.
1. Align the lift ribs on the battery pack with the
grooves in the battery compartment.
2. Push the battery pack into the battery compartment
until the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
3.6 REMOVE THE BATTERY PACK
Figure 5.
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
4 OPERATION
IMPORTANT
Before you operate the machine, read and understand
the safety regulations and the operation instructions.
WARNING
Be careful when you operate the machine.
4.1 START THE MACHINE
Figure 6.
1. Push the on/off button.
2. Push the lock-out button and pull the trigger.
3. Push the speed button to adjust the speed
according to the grass condition.
English
4.2 STOP THE MACHINE
Figure 6.
1. Release the trigger to stop the machine.
4.3 ADJUST THE LENGTH OF THE
CUTTING LINE
Figure 6.
The machine has an auto-feed head. It will damage
the machine if you hit the head to try to advance the
line.
If the cutting line does not automatically advance, it
can be tangled or empty.
1. When the machine is on, release the trigger.
2. Wait two seconds, push the trigger again.
The line will extend approximately 0.4 in. with each
stop and start of the switch trigger until the line
reaches the cut-off blade and the cut-off blade cuts
the excess length.
4.4 ADJUST THE LENGTH OF THE
SHAFT
Figure 7.
You can adjust the length of the shaft to operate the
machine easily.
1. Stop the machine.
2. Push the lock button and move the lower shaft to
the desired position.
3. Release the lock button.
4.5 CHANGE TO THE EDGING MODE
Figure 8 - 9.
The machine can be used in combination with the
edge guide for edging sidewalks and walkways.
1. Stop the machine and flip down the edge guide from
stored position.
2. Push the lock button and turn the lower shaft 90° or
180° until it engages.
3. Release the lock button.
5
NOTE
NOTE
NOTE
NOTE
NOTE
EN