GreenWorks G24LT30K2 Bedienungshandbuch Seite 8

EN
1 DESCRIPTION
1.1 PURPOSE
This machine is used to cut grass, light weeds, and
other similar vegetation at or around ground level. The
cutting plane must be approximately parallel to the
ground surface. You cannot use the machine to cut or
chop hedges, shrubs, bushes, flowers and compost.
1.2 OVERVIEW
Figure 1 - 19.
Trigger
1
Lock-out button
2
Rear handle
3
Auxiliary handle
4
Upper shaft
5
Lower shaft
6
Motor housing
7
Edge guide
8
Cutting line
9
Trimmer head
10
Guard
11
Lock button
12
Knob
13
Bolt
14
Battery release button
15
Cut-off blade
16
Tab
17
Spool cover
18
Spool
19
Spool housing
20
Eyelet
21
Anchor hole
22
Guide slot
23
Direction of rotation
A
Best cutting area
B
Dangerous cutting area
C
2 GENERAL POWER TOOL
SAFETY WARNINGS
Read all safety warnings and all instructions.
Failure to follow the warnings and instructions may
result in electric shock, fire and/or serious injury.
Save all warnings and instructions for future
reference.
WARNING
English
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
3 INSTALLATION
3.1 UNPACK THE MACHINE
Make sure that you correctly assemble the machine
before use.
• If parts of the machine are damaged, do not use
the machine.
• If you do not have all the parts, do not operate the
machine.
• If parts are damaged or missing, contact the
service center.
1. Open the package.
2. Read the documentation provided in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and packing material in compliance
with local regulations.
For your personal safety, do not insert battery before
the tool is assembled completely.
3.2 ATTACH THE EDGE GUIDE
Figure 2.
The edge guide can limit the cutting range of the
machine and decrease the risk of the damage caused
by the rotating cutting line.
1. Push the edge guide onto the trimmer head until it
engages in the slots.
2. The edge guide can be flipped up for storage.
3.3 ATTACH THE GUARD
Figure 3.
Do not touch the cut-off blade.
1. Remove the screws from the trimmer head with a
Phillips head screwdriver (not included).
2. Put the guard onto the trimmer head.
3. Align the screw holes on the guard with the screw
holes on the trimmer head.
4
WARNING
WARNING
WARNING
NOTE
WARNING