Makita PW5000C Betriebsanleitung Seite 8

ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and unplugged before carrying out
any work on the tool.
Installing side grip (handle)
CAUTION:
Always be sure that the side grip is
installed securely before operation.
Screw the side grip securely on the position of the tool
as shown in the figure.
► Fig.6
Installing or removing abrasive disc
1. Remove all dirt or foreign matter from the pad.
2. Screw the pad onto the spindle with pressing the
shaft lock.
3. Attach the disc to the pad so carefully that the
edges of disc and pad overlap each other without
protruding.
► Fig.7: 1. Abrasive disc 2. Pad 3. Spindle
To remove the abrasive disc, pull off its edge from the
pad.
► Fig.8
OPERATION
WARNING:
To reduce the risk of electric
shock, check the tool's water supply system to
ensure there is no damage to the seals ("o" rings)
or hoses. A damaged water supply system may
result in abnormal water flow to the tool, which could
be dangerous.
CAUTION:
Never switch on the tool when it
is in contact with the workpiece, it may cause an
injury to operator.
CAUTION:
Always wear safety goggles or a
face shield during operation.
CAUTION:
ALWAYS hold the tool firmly with
one hand on housing and the other on the side
grip (handle).
CAUTION:
Never run the tool without the
abrasive disc. You may seriously damage the pad.
CAUTION:
Be sure to feed water to the abra-
sive disc during operation. Failure to do so may
cause breakage to the tool.
CAUTION:
The maximum permitted pressure
of water supply is 7 bar.
Polishing operation
Make sure that the cock is closed.
Connect the hose to the tool.
Make sure that water comes out when the water lever
is opened.
► Fig.9
Turn the tool on and then apply the abrasive disc to the
workpiece.
Apply slight pressure only. Excessive pressure will
result in poor performance and premature wear to
abrasive disc.
MAINTENANCE
CAUTION:
Always be sure that the tool is
switched off and unplugged before attempting to
perform inspection or maintenance.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
To maintain product SAFETY and RELIABILITY, repairs,
carbon brush inspection and replacement, any other
maintenance or adjustment should be performed by
Makita Authorized or Factory Service Centers, always
using Makita replacement parts.
Air vent cleaning
The tool and its air vents have to be kept clean.
Regularly clean the tool's air vents or whenever the
vents start to become obstructed.
► Fig.10: 1. Exhaust vent 2. Inhalation vent
OPTIONAL
ACCESSORIES
CAUTION:
These accessories or attachments
are recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons. Only use accessory or attachment
for its stated purpose.
If you need any assistance for more details regard-
ing these accessories, ask your local Makita Service
Center.
• Side grip
• Abrasive disc
• Dust cover attachment
• Pad
NOTE: Some items in the list may be included in the
tool package as standard accessories. They may
differ from country to country.
8 ENGLISH