Leica Geosystems Digisystem Gebrauchsanweisung Seite 38

Digisystem, How to Use the Transmitter
Using the Transmitter
in Induction mode

1. Switch the Transmitter on, observe the Induction mode LED is illuminated and the
battery level is adequate. Change batteries when indicated.
2. Select the required power output level and frequency output.
3. Place the Transmitter over the service with the arrows running in line with the suspected
direction of the service.
4. The tracing signal is induced directly onto the service from the internal aerial.
5. Trace the suspected path of the service using the Locator set to the same frequency.
Refer to "2 How to Use the Locator" for more information.
• Work at least 10 m / 33 ft away from the Transmitter to avoid airborne signals. Reposi-
tion the Transmitter if required.
• Coupling efficiency is best at 33 kHz.
• The signal will couple to adjacent services dependent on depth and direction.
• Reducing the signal output can help to increase the battery life and the Transmitter is
less likely to apply a signal to an adjacent service.
3
1
37
2