Leica Geosystems Digisystem Gebrauchsanweisung Seite 20

2.5
Start up test
Locating process
Digisystem, How to Use the Locator
How to Locate a Service
The following test sequence will take place every time the Locator is activated.
On test
Audio Output
Signal Strength indicator Scrolls through in
Mode indicators
Battery indicator
Bluetooth and wrench
Measurement unit,
display readout, depth
mode indicator
The unit will then go into Power mode maximum sensitivity.
The locating process is split into three steps:
• Sweep Search
• Pinpointing the service
• Direction of the service
Test pattern
On throughout test
sequence
sequence once
Briefly illuminated
On throughout test
sequence
Briefly illuminated
Briefly illuminated
MEM displayed in display
readout (600i & 650i)
Info on label
F
i
19