Mennekes 96438 Montage & Betriebsanleitung Seite 37

7.2 Removing electrical consumers
Warning
Risk of injury due to improper operation
Improper operation may cause damage to the device,
which may result in injuries.
• Always disconnect the device plug from the socket by
pulling the plug housing.
• Do not disconnect the plug by pulling at its cable.
• Ensure that the cables are not kinked, pinched or run over,
and will not make contact with external heat sources.
7.2.1 Removing the electrical consumer from the
device according to protection class IP 44
• First switch off the connected electrical consumer.
• Then slightly raise the hinged lid of the socket and pull the
plug out of the socket.
7.2.2 Removing the electrical consumer from the
device according to protection class IP 67
3
1 2
Removing electrical consumers
• First switch off the connected electrical consumer.
• Loosen the bayonet ring (1) of the plug (2) by turning it
counter-clockwise.
• Then slightly raise the hinged lid (3) of the socket and pull
the plug out of the socket.
• Turn the hinged lid (3) clockwise to close it so that it
is hand-tight and to ensure that the protection class
requirements are met again.
7.3 Inspection window
7.3.1 Opening the inspection window with knurled
screws
2
Inspection window with knurled screws
• If applicable, remove the padlock (1).
• Turn the knurled screws (2) counter-clockwise to loosen
them.
• Swivel the inspection window (3) upwards to open it.
7.3.2 Closing the inspection window with knurled
screws
• Swivel the inspection window downwards.
• Tighten the knurled screws so that the protection class
requirements (e. g. IP 67) are met again.
• If required, lock the inspection window by means of the
padlock.
1
3
EN EN
EN EN
NL NL
FR FR
IT IT
15