Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2.2
Target groups
2.2.1 Qualified electrician
The assembly, removal, installation, start-up and mainte-
nance of the device must only be carried out by a quali-
fied electrician. The electrician must meet and observe the
following requirements:
– Comply with information given in the installation and
operating instructions in all aspects
– Ensure that the device is used as intended
– Knowledge and application of relevant electrotechnical
regulations (e.g. DIN VDE 0100, part 600,
DIN VDE 0100, part 410) as well as the national regula-
tions for the installation of electrotechnical systems.
– Knowledge of general and special regulations pertaining
to safety and accident prevention.
– Ability to recognise risks and avoid possible hazards.
– Transfer of installation and operating instructions to the
owner / user of the device
2.2.2 Owner / user
The owner / user must ensure the proper use of the device
and is responsible for its safe operation.
The device may be operated by persons with or without
electrotechnical training. The operator / user must meet and
observe the following requirements:
– Comply with information given in the installation and
operating instructions in all aspects
– Permanent storage of installation and operating instruc-
tions for reference
– Ensure that the device is used as intended
– Instruct persons who use the device
– Recognise risks and avoid possible hazards
– Consult a qualified electrician in the event of failures or
for work which may only be carried out by a qualified
electrician.
– Protect persons (e.g. people with handicaps or children)
who are not able to accurately assess the hazards associ-
ated with using the device.
– Observe the national accident prevention and work pro-
tection regulations
2.3
Foreseeable misuse
To ensure the safe use of the device and to avoid misuse,
the following points must be complied with:
Failure to observe the information given in the instal-
lation and operating instructions
• Observe all of the information given in the installation and
operating instructions for carrying out any task.
• Only perform the tasks which are described in these
installation and operating instructions.
• Observe the procedure and sequence for the described
work steps.
Operation of a device that has not been completely
installed, is damaged, or incorrectly connected
• Only have a qualified electrician connect the device, put it
into service and maintain it.
• Only operate the device, if it has been completely installed,
is undamaged, and if an electrician has executed the
proper start-up procedure.
Manipulation of the device
• Do not remove any parts of the device.
• Do not perform any modification to or conversion of the
device.
Installation work on the device with the supply volt-
age switched on (electrician!)
• Switch off the supply voltage before commencing
installation work on the device.
Use of unsuitable cleaning agents
• Obtain prior approval from MENNEKES for cleaning agents
you would like to use.
Use of unapproved replacement parts and accessories
• Only use replacement parts and accessories manufactured
and/or approved by MENNEKES.
Operation of the device under unsuitable ambient
conditions
• Only operate the device under the ambient conditions that
have been approved and are suitable for this.
Ö
Please refer to the "Technical Data" chapter
EN
EN
EN
EN
NL
NL
FR
FR
IT
IT
5
Werbung
