urmet 1093/182WM1A Schnellanleitung Seite 10

If you are using a NVR/HVR device, assign a static IP address to the camera and use the
7.
NVR/HVR menu to add the camera to a recording channel.
4 HOW TO CONFIGURE THE CAMERA IN A NETWORK
In this section explanation is provided to configure the camera in the network and to connect it
remotely from the smartphone App or from a PC.
IMPORTANT NOTE: the camera is provided with two different network boards, one for the wire
connection and one for the WiFi connection, each with its own MAC address and is own IP
address.
4.1 HOW TO ADD THE CAMERA TO A WIFI NETWORK FROM THE APP
The camera can be quickly configured on the WiFi network using a smartphone, to do so refer
to the paper Quick Guide of the Urmet App V-Stream provided with the product.
4.2 HOW TO ADD THE CAMERA TO A CABLED NETWORK AND CONNECT
FROM THE APP
Use the LAN cable to connect the camera to the internet router then power the camera, it will get
a dynamic IP address assigned by the router's DHCP service. If the DHCP service is not available
on the network, the camera will automatically assign the default IP 192.168.1.168 to itself.
Download the URMET App V-Stream from the store and use it to connect to the camera by
simply scanning its QR code label, then it will be possible to display the camera's pictures on the
smartphone through the internet.
4.3 HOW TO ADD THE CAMERA TO A WIFI NETWORK USING LAN CABLE AND
PC
Use a network cable to connect the camera to the LAN and power it. The camera will receive an
IP address assigned automatically by the DHCP service of the network. If the DHCP service is
not available on the network, the camera will automatically assign the default IP 192.168.1.168
to itself.
The following steps are needed for configuration:
Start "EasyTool" on the PC by selecting
1.
mask, gateway and MAC address of each IP camera active on the LAN will be
automatically displayed, as shown in the figure below.
10
: the IP address, subnet
DS1093-601