Cause And Action - Caso VC10 silber Bedienungsanleitung

18.2 Cause and Action

Error
Vacuum unit is not
functioning
The first weld on the
cut off piece of the roll
is not being carried
out.
A complete vacuum is
not being created in
the bag.
The bag is not being
welded correctly
The bag does not hold
the vacuum after it has
been welded shut
caso Vakuumierer VC10
In the event of a fault, an error code will appear in the display; it
describes the cause of the fault.
Possible cause
Power plug is not plugged in
Defective power cable or plug
Defective electrical socket
Roll is not positioned
correctly
The open end of the bag is
not completely inside the
vacuum chamber
The bag is defective
There is dirt on the welding
and the normal seals
The welding bar is
overheating so that the bag
melts
The bag is defective
There are leaks along the
welding seam as a result of
creases, crumbs, grease or
liquids.
► If you are unable to solve the problem with the steps shown
above, please contact Customer Service.
► Plug in mains plug!
► Send device to Customer
Service
► Select another electrical
socket
► Follow the steps in the
chapter "Vacuum packaging
in a bag originating on the
roll"
► Position the bag correctly
► Select another bag
► Clean the seals and retry
correctly once they are dry
► Open the cover on the unit
and let it cool down for a few
minutes
► Select another bag; wrap
paper serviettes around any
sharp edges on the content
► Open the bag again and
clean the upper internal part
of the bag and remove any
foreign matter that might be
on the welding bar before you
weld the bag shut again.
Please note
Troubleshooting
Rectification
57