Massoth eMOTION LS Bedienungsanleitung Seite 39

CV - Table (drive settings)
This table shows the standard settings of the S-decoder. (D = Default, A = analog operation)
Table of configuration variables
CV Description
1 Loco address (Standard short)
2 Starting voltage
3 Acceleration time
4 Braking time
5 Top speed
6 Mid speed
5+6 Programming in register mode:
Reg 6 = CV No. ; Reg 5 = Value
7 Software version
7 Decoder reset functions
5 ranges available.
Value 55 available with programming
lock.
(see also attachment 10)
8 Manufacturer ID
9 Motor Frequency
Function outputs in analog mode
13
(On if value set)
15 Programming lock
16 Programming lock
17 Long loco address (High Byte)
18 Long loco address (Low Byte)
19 Multiple Unit Address
D A Range Note:
3 1... 127 If CV 29 bit 5 = 0
2 1... 255 CV 2 x (1/255 track voltage)
3 √ 1... 255 CV 3 x 2ms x (1/255 track v.)
3 √ 1... 255 CV 4 x 2ms x (1/255 track v.)
255 √ 1... 255 CV 5 x (1/255 track voltage)
64 1... 255 CV 6 x (1/255 track voltage)
--- --- CV 5 and CV 6 are not effected
--- --- read only
55 basic setting
77 reset lights and functions
111 reset CV 131 – 167
122 reset CV 171 – 199
133 reset CV 200 – 212
123 --- read only
0 √ 0... 3 0 = 16 kHz
1 = 2 kHz
2 = 250 Hz
3 = 60 Hz
A3 = 4 Add the values to the
3 √ 0... 63 A7 = 64 desired functions!
A8 = 128
144 0/CV16 Programming release
144 Fixed value LS-Decoder
128... Only active
128
10239 if CV 29 bit 5 = 1
1... 99
39