Werbung
Verfügbare Sprachen
Verfügbare Sprachen
SIMATIC
Customized automation
SIMATIC IPC477E 1900 PRO HD LR Ext.
Product Information
A5E44290044
Valid scope
This Product Information applies to SIMATIC IPC477E 1900 PRO HD LR Ext., suitable for support arm and extension
components, article number 6AV7255-6KA00-0LF0.
This device is also referred to as "PRO device" and "PRO version".
The device is based on the IPC477E PRO 19" device with capacitive multi-touch screen with regard to mechanics,
electronics and interfaces, and provides the corresponding scope of functionality. You can find a description of the PRO
devices in the "SIMATIC IPC477E PRO" operating instructions
(https://support.industry.siemens.com/cs/ww/en/view/109749400) on which this product information is based.
This product information describes the technical differences of the SIMATIC IPC477E 1900 PRO HD LR Ext. compared to
standard device SIMATIC IPC477E PRO.
Unless otherwise described in this product information, all specifications in the underlying operating instructions, i.e.
specifications regarding hardware, software, maintenance and service, apply to this device.
The statements in this product information take precedence over statements in the operating instructions, the Quick Install
Guide, the release notes and online help.
Scope of delivery and accessories
The following components are included in the scope of delivery:
● 1 SIMATIC IPC477E 1900 PRO HD LR Ext.
● 1 flange mount adapter for support arm mounting
● 1 basic adapter for support arm or pedestal mounting
● 1 supplemental accessory kit PRO HD LR Ext. (see below)
Extension Units with connection tube and mounting hardware are not supplied with the device and can be ordered
separately.
Supplemental accessory kit PRO HD LR Ext.
The device has been prepared for lateral mounting of 1-2 Extension Units. For the installation of the Extension Units you
need the enclosed supplemental accessory kit.
This section describes the content of the accessory kit with article number A5E41596544A at the time this document was
created:
● 4 connection pieces for mounting of Extension Units
● 1 blanking cover for the basic adapter or the flange mount
● 4 M6x10 screws for fastening the blanking cover on the basic adapter
● 4 M6x16 screws for fastening the blanking cover on the flange mount
● 4 M4x30 countersunk head screws
● 4 M4x20 pan head screws
● 4 M4x10 plastic screws for covering threaded holes on the PRO device that are not used.
● 1 slot bit size 5/16 " for installing the plastic screws
Additional documents may be supplied with the accessory kit.
© Siemens AG 2018. All rights reserved
12
A5E44290044-AA, 03/2018
Werbung
