Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Start up
Check mains cable and plug for dam-
age or breakage. Get them replaced
only through customer service agent or
an electrician.
Check appliance for transport damage.
Do not use the appliance if it is dam-
aged.
Insert brushes
Disconnect the mains plug from the
socket.
Open both latches on the appliance
cover.
Open the device hood.
Pull both suction hoses off the brush
cover.
Swing the brush cover to the front.
Remove clips from the brush rollers.
Slide brush rollers onto the brush shafts
and lock by turning them into the towing
arm.
With brush rollers with bristles running
diagonal to the rotating shaft, the bristle
rows of these two brushes should form
a V (viewed from the pushing handle).
Slide the clips onto the brush shafts and
lock.
Close brush cover.
Connect the suction hoses to the brush
cover.
Close and lock the appliance cover.
Transport
Push the pushing handle back, so that
the brush rollers lift off the floor.
Push the appliance to the work area at
the lower end of the escalator with the
brush rollers lifted off the floor.
Preparing the travellator/ escalator
DANGER
To be on the safer side, make sure that you
know where the emergency switch-off but-
ton of the travellator/escalator is located.
Block off a large area around the travel-
lator/escalator while the cleaning is be-
ing performed.
Switch on the travellator/ escalator.
Ensure that the running direction of the
travellator/ escalator is away from the
machine.
Operation
DANGER
Risk of injury!
– Hold the pushing handle firmly with at
least one hand.
– Loose fitting clothes and jewellery can
get entangled in the moving parts of the
travellator/ escalator. Hence, remove
jewellery and wear clothes fitting well
on the body and safety shoes.
Check bristle length of the brush rollers.
If the bristles are shorter than 35 mm,
there is a risk of damage to the travella-
tor or escalator.
Drive the machine in front of the travel-
lator/ escalator platform.
DANGER
Risk of injury and electrical shock! Always lay
the extension cable in such a way that it does
not get jammed or crushed and also does not
cause somebody to stumble over it.
Do not run cable near the roller brushes.
WARNING
The highest allowed net impedance at the
electrical connection point (refer to techni-
cal data) is not to be exceeded. In case of
confusion regarding the power impedance
present on your connection, please contact
your utilities provider.
Plug in the mains plug.
Hook the loop of the mains cable onto
the tensioning release hook.
Place appliance in front of the escalator
so that the standing strip is located on
the fixed comb of the escalator.
Switch on "suction" button.
Switch on "brush drive" button.
The cleaning process will start.
After the escalator has made a full cy-
cle, move the appliance to the side and
thus clean the entire width of the esca-
lator.
Shutting down
Switch off "brush drive" button.
Switch off "suction" button.
Remove the appliance from the escala-
tor.
Move the pushing handle into the park
position to store the appliance: Fold the
pushing handle in and lock using the
latch in the cover.
Transport
CAUTION
Risk of personal injury or damage! Mind the
weight of the appliance during transport.
When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.
Storage
CAUTION
Risk of personal injury or damage! Consid-
er the weight of the appliance when storing
it.
This appliance must only be stored in inte-
rior rooms.
2
-
EN
Care and maintenance
WARNING
Risk of injury, risk of damage!
Prior to all work on the appliance, switch off
the appliance and pull the power plug.
Cleaning the device
ATTENTION
Risk of damage. Do not sluice the appli-
ance with water and do not use aggressive
detergents.
Clean the outside of the appliance with
a damp cloth which has been soaked in
mild detergent.
Remove the brush rollers, rinse under
flowing water and let them dry.
In order to avoid deformation of the bris-
tles, store the appliance without load
(see "Shutting down") or with the brush
rollers removed.
Replacing the filter bag
Disconnect the mains plug from the
socket.
Open both latches on the appliance
cover.
Open the device hood.
Pull the filter bag off both connection
necks and discard.
Clean the motor protection filter if the fil-
ter bag is damaged.
Insert new filter bag and slide onto both
connection necks.
Close cover.
Troubleshooting
DANGER
Pull the plug from the mains before carrying
out any tasks on the appliance.
Fault
Remedy
Appliance can-
Plug in the mains plug.
not be started
Check power supply and
ensure proper supply.
Check the mains connec-
tion cable for damages.
Replace the defective
mains cable.
Appliance stops
Check the brush rollers for
during operation
damages.
Check connectors on
mains cable, extension
cables.
Appliance vi-
Check for correct installa-
brates.
tion of the brush rollers.
Check the brush rollers for
wear.
Suction capacity
Replace filter bag or re-
decreases
move the blockage.
Clean motor protection fil-
ter.
7
Werbung
