R&G IA0006BK Montageanleitung Seite 18

Page 18 of 18
• Benutzen Sie einen 10mm Steckschlüssel und entfernen Sie die 4x Muttern, die den original
Kennzeichenhalter und die Halterung für den Sicherungskasten befestigen – siehe Abbildung
31. Den Kennzeichenhalter vorsichtig herabsetzen und die Kabel durch die Öffnung im
Hilfsrahmen führen.
• Entfernen Sie die zwei Schrauben an der Unterseite und die zwei Schrauben hinten am
Kennzeichenhalter, um die Kunststoffabdeckung zu entfernen und somit die Kabel freizulegen –
siehe Abbildung 32.
• Entfernen Sie die Halteplatten für die Blinker an beiden Seiten, die in Abbildung 33 abgebildet
sind, indem Sie sie von beiden Seiten der Gummidichtung lösen und die Blinker-Stiele
zusammendrücken, um die Blinker zu entfernen.
• Montieren Sie die Ersatz-Miniblinker wie zuvor für die Montage vorne am Motorrad beschrieben,
und montieren Sie den Kennzeichenhalter wieder. Überprüfen Sie die ordnungsgemäße
Funktion der kompletten Beleuchtung bevor Sie mit dem Motorrad fahren.
The catalogue description and any exhibition of samples are only broad indications of the Products and R&G may make design changes which do not diminish their
performance or visual appeal and supplying them in such state shall conform to the order. The Buyer acknowledges no representation or warranty (other than as to title)
has been given or will apply to the Products other than those in R&G's order or confirmation and the Buyer confirms it has chosen the Products as being of merchantable
quality and suitable for its particular purposes. Where R&G fits the Products or undertakes other services it shall exercise reasonable skill and care and rectify any fault free
of charge unless the workmanship has been disturbed. The Buyer is responsible for ensuring that the warranty on the motorcycle is not affected by the fitting of the
Products. On return of any defective Products R&G shall at its option either supply a replacement or refund the purchase money but shall not be liable if the Products have
been modified or used or maintained otherwise than in accordance with R&G's or manufacturer's instructions and good engineering practice or if the defect arises from
accident or neglect. Other than identified above and subject to R&G not limiting its liability for causing death and personal injury, it shall not be liable for indirect or
consequential loss and otherwise its liability shall be limited to the amounts paid by the Buyer for the Products or the fitting or service concerned. These terms do not affect
the Buyer's statutory rights.
Returns must be pre-authorised (if not pre-authorised the return will be rejected). Goods may only be returned direct to us if they were purchased direct from us (customer
must prove if necessary). Otherwise to be returned to original vendor. Goods must be in re-sellable condition, in the opinion of R&G Racing. All returns are subject to a
25% restocking and handling fee (25% of the gross value exc. P&P – at the prevailing price at time of purchase). The customer must pay any and all carriage charges. No
returns of discontinued products, unless within 14 days of purchase. This policy does not affect your statutory rights and does not refer to faulty goods.
Unit
Tel: +44 (0) 420 89007 Fax: +44 (0)
1
AUSGABE 1
R&G RACING RETURNS POLICY (NON-FAULTY GOODS)
, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
1
420 87301
1
25/04/2019 (FB)
CONSUMER NOTICE
R&G
www.rg-racing.com
IA0006BK
Email: info@rg-racing.com