Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Problem
Possible cause
The BRA 3 / VRA
1. The standby function is factory set to NSB.
3 does not turn on
The system must be turned on manually.
automatically.
2. The device has been switched off via the
"ON / Standby" button of the remote control
or the "Power" button of the TV remote
control (when using the IR learning function).
3. The signal at AUX (Line) input is too low.
BRA 3 / VRA 3
1. The standby function ECO, AUT, LAN or NSB is
switches off
activated..
automatically.
2. The infrared command for Standby has been
learned incorrectly.
BRA 3 / VRA 3
1. The standby function MAN is activated.
does not turn off
2. The standby function AUT or NSB is activated
automatically.
and the source device also transmits a carrier
signal in standby mode (optical or coaxial
digital input, only).
Solution
1. Switch the standby function to AUT.
2.1. Switch on the BRA 3 / VRA 3 via the "ON / Standby"
button of the remote control and wait until it automati-
cally switches to the standby mode, next time.
2.2. Delete the "Power" button of your TV remote from the
BRA 3 / VRA 3 to prevent it from switching off together
with your TV.
3. Increase the output level on your source device.
1. Select the standby function MAN.
2. Learn the infrared command for Standby again.
1. Activate the standby function ECO, AUT, LAN or NSB.
2. Disconnect the source device from the mains or
manually switch off the BRA 3 / VRA 3.
English
3 9 3
Werbung
